On the build orientation effect in as-printed and as-sintered bending properties of 17-4PH alloy fabricated by metal fused filament fabrication.
In: Rapid Prototyping Journal, Jg. 28 (2022-06-01), Heft 6, S. 1076-1085
academicJournal
Zugriff:
Purpose: The purpose of this paper is to systematically investigate the influence of build orientation on the anisotropic as-printed and as-sintered bending properties of 17-4PH stainless steel fabricated by metal fused filament fabrication (MFFF). Design/methodology/approach: The bending properties of 17-4PH alloy fabricated by low-cost additive manufacturing (MFFF) using three build orientations (the Flat, On-edge and Upright orientations) are examined at both as-printed and as-sintered states. Findings: Unlike tensile testing where the Flat and On-edge orientations provide similar as-sintered tensile properties, the On-edge orientation produces a significantly higher bending strain with a lower bending strength than the Flat orientation. This arises from the printed layer sliding due to the Poisson's effect, which is only observed in the On-edge orientation together with the alternated layers of highly deformed and shifted voids. The bending properties show that the Upright orientation exhibits the lowest bending properties and limited plasticity due to the layer delamination. Originality/value: This study is the first work to study the effect of build orientation on the flexural properties for MFFF. This work gives insight information into anisotropy in flexural mode for MFFF part design. [ABSTRACT FROM AUTHOR]
Copyright of Rapid Prototyping Journal is the property of Emerald Publishing Limited and its content may not be copied or emailed to multiple sites or posted to a listserv without the copyright holder's express written permission. However, users may print, download, or email articles for individual use. This abstract may be abridged. No warranty is given about the accuracy of the copy. Users should refer to the original published version of the material for the full abstract. (Copyright applies to all Abstracts.)
Titel: |
On the build orientation effect in as-printed and as-sintered bending properties of 17-4PH alloy fabricated by metal fused filament fabrication.
|
---|---|
Autor/in / Beteiligte Person: | Suwanpreecha, Chanun ; Manonukul, Anchalee |
Zeitschrift: | Rapid Prototyping Journal, Jg. 28 (2022-06-01), Heft 6, S. 1076-1085 |
Veröffentlichung: | 2022 |
Medientyp: | academicJournal |
ISSN: | 1355-2546 (print) |
DOI: | 10.1108/RPJ-07-2021-0174 |
Schlagwort: |
|
Sonstiges: |
|